Contents

1. Components Identification
2. First use: how to choose the correct power source
3. First use: switch on and activation of wireless network
4. First use: Setting remote control with iPhone or iPad
5. First use: Setting remote control from a Windows computer
6. First use: Setting remote control from a Mac computer
7. First use: Setting remote control from an Android device
8. First use: create a recovery drive with Windows 11 tool before installing your software
9. First use: install your software
10. First use: set your local time
11. First use: install your USB devices
12. First use: turn off EAGLE
13. First use: installing EAGLE on the telescope
14. First use: powering other instruments connected to the EAGLE
15. First use: EAGLE Manager X to check connectivity and sensors
16. - connect or disconnect every power out port of EAGLE
17. - set power out voltage of the 3 power out ports with adjustable voltage
18. - connect or disconnect devices attached to the 4 USB 2.0 ports
19. - check for power in voltage and power consumption
20. - Set wireless or wired connectivity
21. - Check for Inclinometer
22. remotely turn on/off the entire telescope
23. - change the password of the WiFi network created by EAGLE
24. - Check for GPS data
25. - EYE sensor data
26. - DARK mode
27. - GHOST mode
28. - Use Observatory Actions: the CTRL-IN port
29. - Use Observatory Actions: the CTRL-OUT port
30. - Use Lights-out Management (LOM)
31. First use: EAGLE Manager X to simplify devices connectivity
32. Advanced use: EAGLE ASCOM drivers
33. Advanced use: program connection and power to devices
34. Advanced use: Three ways to remotely turn your EAGLE on
35. Q & A
36. Add EAGLE’s ports control in external software
37. Troubleshooting